Allied Telesis AT-S39 - Manual (Page 209)

AT-S39 User’s Guide
209
Displaying a Bridge or Port’s STP Settings
To display the STP settings, perform the following procedure:
1. From the Home page, select Monitoring.
2. From the Monitoring menu, select Layer 2.
3. From the Layer 2 page, select the Spanning Tree tab.
The Spanning Tree window in Figure 67 is displayed. The
information in this window is for viewing purposes only. To
change the parameters or for definitions of the parameters, refer
to Configuring a Bridge or Port’s STP Settings on page 205.
Figure 67 Spanning Tree Window - Monitoring
4. To view port settings, click a port in the switch and click Status. You
can select only one port at a time.