Allied Telesis AT-S39 - Manual (Page 220)

Section III: Web Browser Management
220
Changing a PVID
The procedure in this section explains how to change a PVID value for a
port. As explained in Port-based VLAN Overview on page 93, a port
receives a PVID when it is assigned as an untagged port to a VLAN. A
port’s PVID will be the same as the VLAN’s VID to which it has been
assigned. For example, if you assign Port 4 on the switch as an untagged
port to a VLAN with a VID of 7, the port is assigned a PVID also of 7.
The assignment of PVIDs is performed automatically by the AT-S39
software. There should be little need for you to manually change a PVID
yourself. But the AT-S39 software does allow you to adjust the value if
necessary.
To change a PVID for a port, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2.
3. From the Layer 2 page, select the COS tab.
A graphical image of the switch is displayed.
4. Click the port whose PVID you want to configure. You can select only
one port at a time. A selected port turns white. To deselect a port, click
it again.
5. Click Apply.
The CoS Setting window in Figure 71 is displayed.
Figure 71 CoS Setting Window