Allied Telesis AT-S39 - Manual (Page 34)

Section II: Local and Telnet Management
34
Configuring an IP Address and Switch Name
The procedure in this section explains how to manually assign an IP
address, subnet mask, and gateway address to the switch from a local or
Telnet management session. (If you want the switch to obtain its IP
configuration from a DHCP or BOOTP server on your network, go to the
procedure Activating the BOOTP and DHCP Services on page 37.)
This procedure also explains how to assign a name to the switch, along
with other optional information, such as the name of the administrator
responsible for maintaining the unit and the location of the switch.
To manually set a switch’s IP address, perform the following procedure:
1. From the Main Menu, type 4 to select Administration Menu.
The Administration Menu in Figure 3 is displayed.
Figure 3 Administration Menu
Note
The selection 9 - Reset Port is described in Resetting a Switch on
page 42. The selection X - Xmodem Downloads is described in
Downloading New Management Software from a Local
Management Session on page 165.
Allied Telesyn AT-8024 Ethernet Switch
Administration Menu
1 - IP Address ......... 0.0.0.0
2 - Subnet Mask ........ 255.255.0.0
3 - Default Gateway .... 0.0.0.0
4 - System Name ........
5 - Administrator ......
6 - Comments ...........
7 - Change Password ....
9 - Reset Switch
X - Xmodem Downloads
L - Release DHCP IP Address
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection: