Allied Telesis AT-S39 - Manual (Page 218)

Section III: Web Browser Management
218
Setting the Switch’s VLAN Mode
This section contains the procedure for setting a switch’s VLAN mode.
You can configure a switch to support port-based and tagged VLANs or
to operate in the Basic VLAN mode.
Note
Refer to Chapter 10, Virtual LANs, for descriptions of port-based
and tagged VLANs and the Basic VLAN mode.
To set the switch’s VLAN mode, perform the following procedure:
1. From the Home Page, select Configuration.
2. From the Configuration menu, choose System.
3. Select the General tab.
4. In the Switch Mode section of the window, click either Tagged or
Basic.
If you select Tagged, which is the default, the switch will support
both port-based VLANs and tagged VLANs. If you select Basic, the
switch will operate in the Basic VLAN mode.
5. Reset the switch. You cannot reset the switch from a web browser
management session. You can reset the unit through a local or Telnet
session or with the reset button on the back panel of the device.