Allied Telesis AT-S39 - Manual (Page 205)

AT-S39 User’s Guide
205
Configuring a Bridge or Port’s STP Settings
Caution
STP on a bridge is disabled by default. If you enable STP, the bridge
provides default STP parameters that are adequate for most
networks. Changing them without prior experience and an
understanding of how STP works might have a negative effect on
your network. You should consult the IEEE 802.1d standard before
changing any of the STP parameters.
To configure a bridge or port’s STP parameters, perform the following
procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select Layer 2.
3. From the Layer 2 window, select the Spanning Tree tab.
The Spanning Tree window in Figure 65 is displayed.
Figure 65 Spanning Tree Protocol Window - Bridge Configuration