Allied Telesis AT-MCF2300 - Manual (Page 97)

Section II: Installation 97
Chapter 9
Removing the Rubber Feet
This procedure is optional. It is used to remove the rubber feet from the
bottom of the chassis. It should only be performed if you’ll be installing the
chassis in an equipment rack. By removing the rubber feet, it may be
possible to install the enclosure closer to the device below it, thus allowing
you to install more devices in the rack. To remove the rubber feet:
1. Place the unit upside down on a level, secure surface.
2. Using a flat-head screwdriver, remove the snap-on plastic feet from the
bottom of the chassis, as shown in Figure 42.
Figure 42. Removing the Chassis Feet
3. Return the chassis to the upright position.
4. Go to the next procedure for instructions on how to install a power
module.