Allied Telesis AT-MCF2300 - Manual (Page 136)

Chapter 20: Powering on the Chassis
136 Section II: Installation
3. Plug the power cord into the AC power connector on the power
module.
Figure 80. Connecting the AC Power Cord
4. Lower the power cord retaining clip to secure the power cord to the
chassis.
Figure 81. Positioning the Power Cord Retaining Clip
5. Plug the other end of the power cord into an appropriate power source.
For the power requirements, refer to “AT-MCF2000AC Power Supply
Module” on page 173 or “AT-MCF2300AC Power Supply Module” on
page 173.
6. Power on the power module by setting the power switch to the ON
position.
7. If there are two power supply modules, repeat this procedure to power
on the second module.
1116-a
AT-MC
F2KPN L3
NORMAL
FAULT
STATUS PSU
FAN
M
A
1117-a
AT-MCF2KPNL3
NORM AL FAULT
STATU S PSU
FAN
M
A