Allied Telesis AT-MCF2300 - Manual (Page 109)

AT-MCF2000 Media Converter Series Installation Guide
Section II: Installation 109
4. Align the edges of the module with the guides in the slot and carefully
slide the module into the chassis until it is flush with the front of the
chassis. Light pressure may be needed to seat the module on the
connector on the backplane in the chassis.
Caution
Do not force the module into place. If there is resistance, remove the
module, verify that the edges of the card are properly aligned in the
guides in the chassis’ module slot, and reinsert it.
Figure 52. Installing a Media Converter Module
5. Tighten the two captive screws on the media converter module with a
cross-head screwdriver to secure the module to the chassis.
Figure 53. Securing a Media Converter Module
6. Repeat this procedure to install additional media converter modules.
1121-a
1
A T -MCF2012LC
AT-M CF2 00 0
1122-a
1
A T -MCF2012LC