Allied Telesis AT-MCF2300 - Manual (Page 135)

Section II: Installation 135
Chapter 20
Powering on the Chassis
This procedure uses the AT-MCF2000 Chassis for illustration purposes.
To apply power to the AT-MCF2000 or AT-MCF2300 Chassis:
1. Set the ON/OFF switch on the module to the OFF position.
Figure 78. Setting the ON/OFF Switch to the OFF Position
2. Raise the retaining clip to the upright position.
Figure 79. Raising the Retaining Clip
AT-MCF2KPNL3
NORM AL FAULT
STATU S PSU
FAN
M
A
ON OFF
AT-MCF2KP
NL3
NORMAL
FAULT
STATUS PSU
FAN
M
A