Allied Telesis AT-MCF2300 - Manual (Page 56)

Chapter 4: AT-MCF2000M Management Module
56 Section I: Features
Overview
The AT-MCF2000M Management Module, together with its AT-S97
Management Software, lets you monitor the operations of the media
converter modules and configure the parameter settings of the ports.
Management is supported both locally (out-of band) through the RS-232
Terminal port on the module and remotely over a network (in-band)
through the 10/100/1000Base-T Ethernet port from Telnet and SSH
clients. The module also features a stacking port which is used with the
AT-MCF2000S Stacking Module to manage more than media converter
chassis at a time.
Note
The AT-MCF2000M Management Module is optional. The
AT-MCF2000 Media Converter Modules can be used as
unmanaged devices.
Figure 24. AT-MCF2000M Management Module
Here are some of the management functions you can perform with the
management module:
❒
Configure the following operating parameters on the twisted pair ports
on the media converter modules:
– Auto-Negotiation
– Speed
– Duplex mode
– MDI/MDI-X configuration
❒
Set the duplex modes of the fiber optic ports.
❒
Set the operating modes of the media converter channels:
AT-MCF200
0M
STAC K
MANAG EMENT
TERMIN AL
10/100/1 000BAS E-T
RS-232
RESET
SD
RDY BUSY MASTE R POWER
BOOT RDY FAULT
1000 LINK
ACT 10/100 LINK
ACT
FDX HDX COL
LINK ACT
PORT A CTIVIT Y
1423
0
31
ID