Allied Telesis AT-MCF2300 - Manual (Page 79)

AT-MCF2000 Media Converter Series Installation Guide
Section I: Features 79
Chassis ID Numbers
To be a member of a stack, a chassis must have a unique chassis ID
number in the range of 0 to 31. (There is no relationship between the
chassis ID range and the maximum number of units in a stack.). You use
the numbers to identify the units when managing them with the
management software.
The ID numbers are assigned with the AT-MCF2000M Management
Module and the AT-MCF2000S Stacking Module. The chassis ID number
on the AT-MCF2000M Management Module can be either 0 or 31 and is
set with a jumper. The default value is 0. The only reason you might
change the jumper is if there will be two management cards in the stack
and you want to assign the second management card the value 31.
Otherwise, there is no reason to change the chassis ID number of a
management card from the default value of 0.
Note
At the time this manual was published, the AT-S97 Management
Software did not support two management cards in a stack. For the
latest information, refer to the Software Release Notes.
Figure 39. Chassis ID Jumper on the AT-MCF2000M Management
Module
The ID number for the AT-MCF2000S Stacking Module has a range of 1 to
30 and is set with DIP switches. The default value is 1. The settings are
provided in Table 35 on page 179 and Table 36 on page 180, and in the
table printed on the module.
AT-MCF200
0M
STAC K
MANAGEM ENT
TER MINA L
10/100/1 000BAS E-T
RS-232
RESET
SD
RDY BUSY MASTER
POWER
BOOT RDY FAULT
1000 L INK ACT 10/100 L INK ACT
FDX HDX COL
LINK ACT
PORT ACTIVITY
1416
0
31
ID
Chassis ID 0
(Default)
Chassis ID 31
Chassis ID Jumper