Apple LaserWriter 12/640 PS - Manual (Page 99)

17 Select LPT1 if the LaserWriter 12/640 PS is connected to your local computer.
18 Click Next.
The Add Printer dialog box appears.
19 Name your computer and select other options as necessary.
20 Click Next.
The printer Properties dialog box appears.
21 Click OK to dismiss the Properties dialog box.
A message appears telling you that the driver software was successfully
installed.
22 Click Add Another to install another Apple LaserWriter printer. Repeat for each printer
you want to install.
You can install other Apple LaserWriter printers supported by the software.
23 When you’re done, click Exit.
Installation is complete.
24 Choose how to proceed:
For users connected via the parallel cable, the default printer driver settings
should suffice.
For instructions on using the Apple LaserWriter Utility for Windows, see
“Setting Additional Parameters With the Apple LaserWriter Utility for
Windows,” later in this chapter.
To configure your printer software with NetWare, see “Initial Novell NetWare
Setup,” later in this chapter.
Installing on a Windows 3.1 computer
1 Find the Windows disks containing the printer software and make sure they’re
write-protected.
Slide up the write-protection tab in one corner of the floppy disk so that you
can see through the hole.
74 Chapter 3