Apple LaserWriter 12/640 PS - Manual (Page 103)

7 Follow the instructions on the screen.
If you are installing software from the Windows NT 3.5 CD, you may need to
type the path for your driver location. The path may be similar to this:
C:\Windows\system 32\spool\drivers\W32x86\1\
If you are installing Windows NT 3.5 software from floppy disks, copy the
following files to the path of your driver location:
PSCRIPTUI.DLL (Disk 13)
PSCRIPT.DLL
(Disk 13)
PSCRIPT.HLP (Disk 18)
8 Click Continue and OK to complete the installation.
Initial Novell NetWare setup
This section provides instructions on setting up the LaserWriter 12/640 PS for
operation on a Novell NetWare network.
Make sure that the NetWare network is set up and operating according to the
instructions in the Novell NetWare documentation.
You should have access to the NetWare Printer Console utility, PCONSOLE,
on the computer from which you will be setting up the printer and have the
administrative privileges necessary to make changes to the network.
Note: The LaserWriter 12/640 PS automatically determines the Ethernet
frame type used by NetWare for network communications. Usually you do
not need to configure frame type when setting up the printer. All of the
file servers that will be using the printer concurrently must use the same
frame type.
If you need to manually set the printer’s Ethernet frame type, see
“Connecting to a Network Printer Manually,” near the end of this chapter.
78 Chapter 3