Managing snmp settings – HP VMA-series Memory Arrays User Manual
Page 84
84
HP VMA SAN Gateway User’s Guide
AM456-9026A
•
Select individual events in a category by clicking the check box next to the name. A check mark
appears when the event is selected. Select the event again to deselect the event and remove the
check mark.
•
Select all the events in a category by clicking the check mark icon on the right side of the header.
•
Deselect all selected events in a category by clicking the X icon on the right side of the header.
•
Reset the selections for a category to the default selections by clicking the star icon on the right side
of the header.
3.
Click Apply to accept your selections, or Cancel to return to the previous settings.
Managing SNMP Settings
You can individually configure several types of SNMP settings through the Web Interface. Simple
Network Management Protocol (SNMP) is an Internet standard protocol for managing and
monitoring devices on an IP network. For more information, see
This section covers the following:
•
Enabling SNMP Management
on page 84
•
Configuring SNMP
on page 85
•
Setting SNMP Trap Sinks
on page 86
Enabling SNMP Management
You can interactively enable and disable SNMP Management from the SNMP Settings page.
To enable or disable SNMP management on your system, do the following:
1.
Select Administration > Notification > SNMP Settings.
2.
In the upper panel, select the Enable SNMP Management check box. A check mark appears
to show SNMP Management is turned on.