Viewing and modifying ntp settings – HP VMA-series Memory Arrays User Manual
Page 72
72
HP VMA SAN Gateway User’s Guide
AM456-9026A
3.
Click Remove Selected.
Viewing and Modifying NTP Settings
The Network Time Protocol (NTP) is a networking protocol for synchronizing the clocks of
computer systems over data networks. You can enable or disable NTP synchronization and add or
remove an NTP server through the NTP Settings page.
When you initially go to the NTP Settings page, information for the NTP server that was configured
in the out-of-box setup is shown.
To enable or disable NTP time synchronization, do the following:
1.
Select Administration > Network > NTP Settings.
2.
To enable NTP, click the Enable NTP Time Synchronization check box. A check mark
appears to show it is enabled. Then click Apply.
3.
To disable NTP time synchronization, click the check marked Enable NTP Time
Synchronization check box. The check mark disappears to show that it is disabled. Then click
Apply.
To enable, disable, or remove an NTP server, do the following:
1.
Select Administration > Network > NTP Settings.
2.
To enable an NTP server, click the check box next the server name in the NTP Servers panel.
Then, click Enable Server.