beautypg.com

Ssh configuration – HP VMA-series Memory Arrays User Manual

Page 195

background image

AM456-9026A

HP VMA SAN Gateway User’s Guide

195

Sets (or clears) a global communication value for all TACACS+ servers. Can be overridden in a

tacacs-server host

command. Sets the shared secret text string used to communicate with any

TACACS+ server.

Add a TACACS+ Authentication Server

[no] tacacs-server host {hostname , ip-address} [auth-port number>][auth-type {ascii, pap}] [timeout ] [retransmit
][key ]

Add a TACACS+ server to the set of servers used for authentication. Some of the parameters given

may override the configured global defaults for all TACACS+ servers. The

auth-port

is used for

authentication requests. The

auth-type

specifies which of the two currently supported

authentication methods will be used.

The same IP address can be used in more than one

tacacs-server host

command as long as

the

auth-port

is different for each.

auth-port

is a UDP port number.

auth-port

must be

specified immediately after the host option (if present).

If

no tacacs-server host {hostname , ip-address}

is specified, all tacacs-specific

configuration for this host is deleted.

no tacacs-server host

{hostname , ip-address}

auth-port

may be specified to refine which host is deleted, as the previous command

will delete all TACACS+ servers with the specified ip-address.

TACACS+ servers are tried in the order they are configured.

Show the TACACS+ Configuration

show tacacs

Show the TACACS+ configuration.

Note:

Currently there is no “single-connection” option on a per TACACS+ server basis.

SSH Configuration

This section provides the syntax for

ssh

server commands, along with an explanation of the

functionality of each command.

This manual is related to the following products: