HP VMA-series Memory Arrays - Manual (Page 166)

166 HP VMA SAN Gateway User’s Guide AM456-9026A
Add or remove an email address from the list of addresses to send email notifications of events.
Specify Failure Event Notification Recipients
[no] email notify recipient class info
[no] email notify recipient class failure
Enable or disable the sending of informational or failure events to the specified recipient. Each
event type is classified as either informational or failure . The specified recipient will receive
the intersection of the set of events specified by this command, and the set of events specified
overall with the [no] email notify event command.
Specify Notification Detail
[no] email notify recipient detail
Specify whether the e-mails this recipient is sent should be detailed or summarized. Each email
potentially has both a detailed and summarized form, where the detailed form has a superset of the
information. (In practice, only PM process failure e-mails currently have a detailed form; for
everything else, the two are the same.)
Specify Email Notification Autosupport
[no] email autosupport enable
Enable or disable the sending of e-mail to vendor autosupport when certain failures occur.
Set the Autosupport Email Relay
email autosupport mailhub no email autosupport mailhub
Set the mail relay to use to send autosupport e-mails.
Send Test Email Notification
email send-test
Send a test email to all of the configured notification email recipients. This is useful to make sure
the configuration works without having to wait for an event to occur.
Display Email Notification Settings
show email