HP VMA-series Memory Arrays User Manual
Page 117
AM456-9026A
HP VMA SAN Gateway User’s Guide
117
media block id
The
media block id
device. The
block
option specifies a vSHARE block media device.
In the following example, the
media block id
command is used to enable a
single block storage media device:
To enable all block storage media devices on a local San Gateway, use the
all
option as described
in
no media block id
To disable a media device, use the
no
form of the
media block id
command.
Caution:
When a block media device is disabled, all applications using that device immediately stop
using it, and will have space from other media allocated for them. This may be a disruptive
operation.
To disable all block storage media devices on a local San Gateway, use the
all
option as described
in
media block id all enable
The
media block id all enable
command enables all block storage media devices on the
local San Gateway.
* gateway02 [cluster1: master] (config) # media block id ?
all Change block media state for all block devices
VTMS0101-2
VTMS0101-4
* gateway02 [cluster1: master] (config) # media block id VTMS0101-2
enable
* gateway02 [cluster1: master] (config) #
█
* gateway02 [cluster1: master] (config) # no media block id VTMS0101-2
enable
Warning: this command will cause users of this media to reset and lose
all content.
Confirm command? [no] yes
* gateway02 [cluster1: master] (config) #
█