HP VMA-series Memory Arrays - Manual (Page 190)

190 HP VMA SAN Gateway User’s Guide AM456-9026A
Enable or Disable HTTPS
[no] web https enable
Enable or disable HTTPS (HTTP over SSL) access to the Web Interface. This setting is only
meaningful if the Web Interface as a whole is enabled.
Specify the HTTPS Port
web https port
no web https port
Set the port number for HTTPS. The default is 443. The no command resets it to the default, but
does not disable HTTPS.
Enable or Disable the Listen Interface
[no] web httpd listen enable
Enable (or disable) the listen interface restricted list for HTTPD. If enabled and at least one non-
DHCP interface is specified in the list, the http connections are only accepted on those specified
interfaces. When disabled, http connections are accepted on any interface.
Add or Remove Listen Interfaces
[no] web httpd listen interface
Provides a mechanism to add and remove interfaces to the “listen” list. If the interface is also
running as a DHCP client, it will be as if the interface was not added. If DHCP is later turned off
on this interface, it will be as if the interface was then added to the listen list.
Control User Inactivity
web auto-logout
no web auto-logout
Control the length of user inactivity required before the Web Interface will automatically log out a
user. The command no web auto-logout disables the automatic logout feature.
Control Web Session Renewal
web session renewal
no web session renewal