HP VMA-series Memory Arrays - Manual (Page 184)

184 HP VMA SAN Gateway User’s Guide AM456-9026A
Ten network bonding modes are supported:
VLAN Commands
A VLAN, or virtual LAN, is a set of nodes that are grouped together into a single logical network,
regardless of their physical location. Multiple VLANs may share the same physical Ethernet links.
The VMA SAN Gateway uses a separate VLAN for low-latency, low-bandwidth communication
between the HP VMA SAN Gateways in a redundant gateway configuration. Using VLAN
commands, interfaces may be configured on a separate VLAN to allow for the segregation of
network and inter-gateway traffic.
Network switches must be configured to provide a VLAN for inter-gateway traffic in the system.
Each network switch port connected to a HP VMA SAN Gateway should be configured to allow
VLAN-tagged traffic for the given VLAN ID.
network vlan vlan-id interface
Creates a tagged VLAN interface with as the specified VLAN ID atop the base
interface . Valid VLAN ID values are between 1 and 4094.
A new interface is created, named vlan# where # is . The new interface can then be
configured using the interface commands.
no network vlan vlan-id
Removes the tagged VLAN interface from its base interface.
show vlans [] [configured]
Displays a list of the configured VLANs in the system, or information about a particular VLAN
interface if one is specified by . If configured is specified, the configured base
interface and for the VLAN interface are shown. Otherwise the current runtime state
of the VLAN interface is shown.
balance-rr Round robin balancing
backup Backup fault-tolerant mode
link-agg Link Aggregation mode
link-agg-
layer2+3 Link Aggregation Layer 2 + 3 mode
link-agg-
layer3+4 Link Aggregation Layer 3 + 4 mode