HP VMA-series Memory Arrays - Manual (Page 175)

AM456-9026A HP VMA SAN Gateway User’s Guide 175
write terminal
write terminal
Same as show running-config , provided for Cisco compatibility.
configuration jump-start
configuration jump-start
Run the initial-configuration wizard. The wizard is automatically invoked whenever the CLI is
launched when the active configuration file is fresh (that is, not modified from its initial contents).
This command invokes the wizard on demand.
show configuration
show configuration [full]
Display a list of CLI commands that will bring the state of the a fresh system up to match the current
persistent state of this system. A short header is included, containing the name and version number
of the configuration, in a comment.
Commands which are not required because they would set something to its default are not
included—thus running this command on a fresh configuration will produce no output, aside from
the header.
Note that this does not include changes that have been made but not yet written to persistent storage.
The full option will also include commands that set things to their defaults, but excludes those of
them that are instances of hidden commands.
show configuration running
Same as show configuration except that it applies to the currently running configuration, rather
than the current persisted configuration. The command show running-config is for Cisco
compatibility.
show configuration files
Displays a list of configuration files in persistent storage.
show configuration files [filename]
If a filename is specified, the commands to recreate the configuration in that file display. In the latter
case, only non-default commands are shown, as for the normal show configuration command;
the full , all , and subtree options are not available.