Network configuration commands – HP VMA-series Memory Arrays User Manual
Page 181
AM456-9026A
HP VMA SAN Gateway User’s Guide
181
Display run state information about standby node.
Cluster Action Commands
[no] cluster heartbeat enable
Enable/disable heartbeat checking between nodes of cluster. This is used to detect communication
failures between cluster nodes.
cluster shutdown
Shutdown cluster (master only).
Cluster Configuration Commands
cluster master address vip
Set the cluster master virtual ip address and netmask.
no cluster master address vip
Reset cluster master virtual address to default.
cluster name
Set the name describing the cluster. This is the cluster equivalent of the hostname.
no cluster name
Reset the cluster name to default.
Network Configuration Commands
This section describes the CLI commands for network configuration.
In general, the commands described in this section (
interface
commands,
network bond
commands,
vlan
commands, and all
ip
commands) only work when you are in Configure mode.
•
•
•
•