HP VMA-series Memory Arrays - Manual (Page 162)

162 HP VMA SAN Gateway User’s Guide AM456-9026A
Enable or disable NTP overall. Note that the latter is the Cisco command; the former is just a pair
of aliases added to increase usability, as otherwise it may be hard for a user to figure out how to
enable NTP if they are not aware of no commands and only see a way to disable it.
Display NTP Settings
show ntp
Display current NTP settings.
Event Notification
This section provides the syntax for event notification commands, along with an explanation of the
functionality of each command.
Enable or Disable Email Notifications
[no] email enable
Enable or disable the sending of email when certain events occur. These events are the same as those
for which SNMP traps can be sent (see SNMP Configuration Commands on page 198).
Set or Clear the Mail Relay
email mailhub
no email mailhub
Set or clear the mail relay to use to send notification e-mails.
Specify the Mail Relay Port
email mailhub-port
no email mailhub-port
Set the mail relay port to use to send notification e-mails. The no variant resets the port to its default,
which is 25.
Specify the Email Notifications Domain Name
email domain
no email domain