HP VMA-series Memory Arrays User Manual
Page 168
168
HP VMA SAN Gateway User’s Guide
AM456-9026A
show files system
show files system
Display information regarding bytes and inodes usage of the file systems on the system.
show memory
show memory
Display information about system memory utilization.
reload
reload [halt] [noconfirm]
Reboot the system if
reload
, shut down the system if
reload halt
.
If there are unsaved changes to the configuration, the user may be prompted as to whether they want
to save these changes (that is, do a
write memory
) first before rebooting. The prompt will be
suppressed if confirmation of losing unsaved changes is disabled (with the
no cli default
confirm lose-unsaved
command).
The user may also be prompted to confirm the reload regardless of whether there are unsaved
changes or not. This prompt is contingent on a separate configuration setting, controlled with the
[no] cli default confirm reload
command. If both prompts are enabled, and the
configuration was unsaved, the user will be prompted twice.
The
noconfirm
parameter suppresses both of these confirmations if it is specified.
reload force
reload force
If the system is busy performing another operation requiring the management subsystem (which is
almost any management operation), the regular reload
[halt]
command will block until it is
finished. If rebooting the system is urgent, the
reload force
command will do it immediately.
This reboots the system, and there is no halt variant. There is also never any confirmation, whether
or not there are any unsaved changes to the configuration.
debug generate dump
debug generate dump