HP VMA-series Memory Arrays - Manual (Page 238)

238 HP VMA SAN Gateway User’s Guide AM456-9026A
fc-port-state-change State Change State One or more Fibre
Channel ports have
changed state on a HP
VMA SAN Gateway.
The old and new
values for state are
provided from one of:
Unknown, Failover
Failed, Failover, Not
Supported, Online,
Lost, Dead,
Unconfigured. The FC
port speed is included
in the data but not used
to generate the state
change. The following
speed values are used:
1 Gbit, 2 Gbit, 4 Gbit,
and 8 Gbit. Verify that OM-3
rate Fibres are used
in your config for 8
Gb. Check that the
Fibres and SFP
ports were properly
cleaned and that the
cables and SFP’s
are fully inserted.
Verify that the Fibre
does not exceed
bend radius
specifications. Medium
interface-down Event Triggered A network interface on
a HP VMA SAN
Gateway has lost link. Check the network
cables to the HP
VMA SAN
Gateway. High
interface-up Event Triggered A network interface on
a HP VMA SAN
Gateway has detected
link up. Nothing. Low
license-state-change State Change State A HP VMA SAN
Gateway feature
license state has
changed. The old and
new active state is
passed as well as the
specific feature
license. The active
state is a “true” or
“false” value. When
true, the feature license
is active. If a license has
changed to active =
false, please contact
HP customer
support to see if
your license has
expired. Medium
lid-ajar State Change Triggered Array lid is open. Close and secure
the lid. High
lid-ajar-time-high 60 Seconds An Array chassis lid is
open Verify Array chassis
lid is closed High
lid-ajar-time-ok 1 Seconds An Array chassis lid
has been closed for at
least this period Nothing. Low
Trap Name Threshold Value Unit Description Solution Sev.