Quick reference to commands, Alphabetical list of commands is provided in – HP VMA-series Memory Arrays User Manual
Page 206
206
HP VMA SAN Gateway User’s Guide
AM456-9026A
Use the
container
option to restrict statistics display to a single container. If
it is omitted, statistics are shown for all the containers accessible to the hosts.
Use the
name
option to get statistics for a single LUN. If it is committed, statistics
for all LUNs are specified.
Note:
Select shell wildcard patterns can be used in the
field to match a set of LUNs.
For example, you can use the asterisk (*) to match all characters that follow. Such as
mylun*
to
match all LUN names that begin with "mylun". Or, you can specify a range of LUN names using
the [a-e] wildcard. Such as
my-lun[2-4][0-9]
to match all LUNs from my-lun20 to my-lun49.
Use the
on global
option to get statistics for data flowing to LUNs through all nodes in a cluster.
Use the
on host
option to get statistics for data flowing to LUNs on a specific host.
Use the
continuous
option to refresh displayed statistics every ten seconds.
Use the
detail
option to display statistics in a verbose format.
Quick Reference to Commands
This section lists the commands that are documented in this guide; it does
not
include every
command that is available in the CLI.
S: Standard Mode
E: Enable Mode
C: Configure mode
no Variant
Command
See section starting on
page #
C
[no]
aaa
C
[no]
arp
C
[no]
banner
E, C
[no]
boot
S, E, C
[no]
cli
C
[no]
clock
C
[no]
cluster heartbeat enable
C
[no]
cluster master address vip
C
[no]
cluster name
E, C
cluster shutdown
C
cluster upgrade
C
configuration
Table A.1 CLI Commands Documented in This Guide