beautypg.com

Set the snmp community name, Set the contact and location variables, Add or remove a host from traps notification – HP VMA-series Memory Arrays User Manual

Page 200: Disable a trap sink, Specify the events sent to snmp traps, Display snmp configuration details

background image

200

HP VMA SAN Gateway User’s Guide

AM456-9026A

Set the SNMP Community Name

snmp-server community
no snmp-server community

Set the community name required to be supplied with SNMP requests to the system.

Set the Contact and Location Variables

snmp-server contact
no snmp-server contact
snmp-server location
no snmp-server location

Set the syscontact and syslocation variable served from the System MIB in MIB-II.

Add or Remove a Host From Traps Notification

snmp-server host traps [version <1,2c>]
no snmp-server host

Add or remove a host to which SNMP traps should be sent. Note that this setting is only meaningful

if traps are enabled, though the list of hosts may still be edited if traps are disabled.

Disable a Trap Sink

[no] snmp-server host disable

Disable a trap sink without actually removing it altogether from the configuration. All trap sinks are

created enabled.

Specify the Events Sent to SNMP Traps

[no] snmp-server traps event

Specify which types of events should be sent as SNMP traps. By default the entire list of notifiable

events are sent as SNMP traps to any declared trap sinks. This command enables or disables a single

event for conversion to an SNMP trap.

Display SNMP Configuration Details

show snmp

Display all SNMP configuration options.

This manual is related to the following products: