HP VMA-series Memory Arrays - Manual (Page 240)

240 HP VMA SAN Gateway User’s Guide AM456-9026A
media-device-state-
change State Change State A HP VMA SAN
Gateway media device
(Array) has changed
state. The possible
states are: unknown,
online, offline, error,
removed, disabled, or
onlining. Verify that the
connected Array is
in the proper online
state. High /
Low
media-device-
unknown-type Event Triggered A HP VMA SAN
Gateway has detected a
media device
connected of an
unknown type. The
Model, Serial #, and
size are provided. The most common
occurrence is a
freshly formatted
Array has been
connected to a HP
VMA SAN
Gateway. The CLI
“media init ...”
command is used to
initialize the device. Low
media-system-swap-
state State Change State An internal SAN
Gateway disk has
changed state for
having an active swap
partition. The active
state is true when a
swap partition has
been activated or false
for deactivation. Please contact HP
customer support. Low
memusage-high 90 Percent A HP VMA SAN
Gateway has detected
that system RAM has
exceeded a percentage
in use threshold. Please contact HP
customer support. Medium
netusage-high 10485760 Bytes / sec A HP VMA SAN
Gateway has detected
that a network
interface has exceeded
a bytes per second
threshold. Please verify your
network
configuration. Low
paging-high 2000 Duration /
sec Memory paging on a
HP VMA SAN
Gateway has exceeded
a threshold. Please contact HP
customer support if
the system is not
under full data
traffic load. Medium
Trap Name Threshold Value Unit Description Solution Sev.