HP StorageWorks IP Storage Router - Manual (Page 99)

Configuring System Parameters
99 IP Storage Router SR2122-2 User Guide
Note: You can verify and save the configuration (by using the
save system bootconfig or save all bootconfig
command) at any
point in the process of performing the configuration tasks.
Figure 45 illustrates the example configuration used in this chapter.
Figure 45: System parameters example configuration
Configuring the Management Interface
Configuring the management interface consists of tasks for setting the system
name, IP address and mask, gateway, and DNS servers. Use the following
procedure to configure the management interface.
If you want external servers, such as RADIUS, TACACS+, or SMTP servers, to
communicate with the SR2122-2 via a specific IP address on a Gigabit Ethernet
interface (for in-band management), configure the IP address on the desired
Gigabit Ethernet interface as described in Step 4. Save the changes to the bootable
configuration (save all bootconfig) and then reboot the storage router.
Note: The purpose of Figure 45 is an example system configuration only. The IP
addresses and all names given below are examples only.
HA Mgmt
HP SR2122-2
HP SR2122-2
Management interface
System Name: SR_2122-MG1
Domain Name: mystoragenet.com
IP: 10.1.10.244
Mask: 255.255.255.0
HA interface
Cluster Name: Mt_Olympus
IP: 10.1.20.56
Mask: 255.255.255.0
Management
Station
IP: 10.1.30.17
Gateway
IP: 10.1.10.201
Primary
DNS server
IP: 10.1.40.243
Secondary
DNS server
IP: 10.1.50.249
NTP server
IP: 10.1.60.86
15041