HP StorageWorks IP Storage Router - Manual (Page 109)

Configuring System Parameters
109 IP Storage Router SR2122-2 User Guide
Verifying and Saving Configuration
Verify the system parameters using the following procedure. You can save the
configuration at any time using either the save system bootconfig or
save all bootconfig
commands. You must save the running configuration
to the bootable configuration for it to be retained in the storage router when it is
rebooted.
To verify configuration information.
1. show system — Display system information, such as system name,
software version, date and time (including time zone), NTP server, DNS
(name server), and management and HA interface IP addresses.
2. show ip route — (Optional) Display the system route table, if you
added any routing information, or if you enabled the storage router for RIP
listening.
3. show ip rip — (Optional) Display RIP configuration and operational
information, if set.
4. show snmp — (Optional) Display SNMP management configuration
information for the storage router, if set.
5. show admin — (Optional) Display contact information for the system
administrator of the storage router, if set.
6. show ssh — (Optional) Display SSH operational status, if configured.
7. show ssh fingerprint — (Optional) Display public key information
for the ssh, if set.
8. show restrict — (Optional) Display the restrict settings, if you make
changes to the protocols allowed for the various SR2122-2 interfaces.
9. show isns — (Optional) Display iSNS configuration information.
10. show bootconfig — (Optional) Display the current boot configuration of
the SR2122-2.
11. show runningconfig — (Optional) Display the current running
configuration of the SR2122-2.