Reset all to factory defaults – HP StorageWorks IP Storage Router User Manual
Page 184
Maintaining and Managing the Storage Router
184
IP Storage Router SR2122-2 User Guide
Note:
If the storage router is operating in a cluster environment, any SCSI routing
instances running on this storage router fail over to another storage router in the cluster.
If you are operating in a cluster environment but do not want SCSI routing instances to
fail over, issue the no scsirouter enable command for all instances (or selected
instances that should not fail over) before you issue the clear conf command. (This
will permanently delete the SCSI routing instances from the cluster.) See the “Controlling
SCSI Routing Instances in a Cluster” section on
for additional information on
operating the storage router in a cluster environment.
3. Run the initial configuration script to configure the management interface via
an EIA/TIA-232 console connection. (Optional)
4. Restore specific configuration information or reconfigure the storage router
using CLI commands or the web-based GUI.
Reset All to Factory Defaults
If an existing storage router is to be physically moved to another environment, and
it is not necessary to retain any current configuration information (system setup
will be completely different):
1. enable — Enter Administrator mode.
2. clear conf or clear conf all HP
— Clear the current system
configuration, including network management information.
For storage routers deployed for SCSI routing, you can use the
Clear Conf
Wizard. At the prompt, enter the Administrator password. Enter all to erase
system configuration and management port settings, and all saved
configurations and SCSI routing instances (
). Entering the CLI
clear conf all
command, followed by the Administrator password (for
example,
hp) will also erase system configuration and management port
settings.
After either of the commands completes, the storage router reboots.
Example 19: Reset storage router Configuration
Enter admin password: *****
This process can restore factory default settings for
the SR2122-2.