Prerequisite tasks, Configuration tasks, Prerequisite tasks configuration tasks – HP StorageWorks IP Storage Router User Manual
Page 98
Configuring System Parameters
98
IP Storage Router SR2122-2 User Guide
Prerequisite Tasks
Before configuring system parameters, make sure you have finished the following
tasks:
■
Completed the hardware installation according to the storage router Hardware
Installation Guide
■
Entered values as requested by the initial system configuration script (for
more information, see “
Initial System Configuration Script
Note:
You do not need to perform the configuration tasks in this chapter if you ran the
complete IP Storage Router Setup Configuration Wizard (using the setup CLI
command with no keyword), or if you ran the wizards separately using all the setup
CLI
commands except setup scsi. However you may wish to perform some of the
optional configuration procedures described in this chapter such as configuring IP
routes or SSH access.
Configuration Tasks
Note:
All configuration tasks require Administrator mode access to the storage router.
To configure system parameters on your storage router:
1. Configure the management interface.
2. Configure the time and date.
3. Configure IP routes. (Optional)
4. Configure network management access. (Optional)
5. Configure passwords.
6. Configure administrator contact information. (Optional)
7. Configure the high-availability (HA) interface. (Optional)
8. Configure for Secure Shell (SSH) access. (Optional)
9. Configure for iSNS communications. (Optional)
10. Verify and save configuration.