beautypg.com

Understanding diagnostics – HP StorageWorks IP Storage Router User Manual

Page 203

background image

Maintaining and Managing the Storage Router

203

IP Storage Router SR2122-2 User Guide

226 Transfer complete

ftp: 374 bytes received in 0.02Seconds 23.38Kbytes/sec.

ftp> binary

200 Type set to I, binary mode

ftp> get

(remote-file) messages0

(local-file) SR2122Sys1_Messages

200 Port set okay

150 Opening BINARY mode data connection

226 Transfer complete

40863 bytes received in 0.049 seconds (8.1e+02 Kbytes/s)

ftp> bye

221 Bye...see you later

If you had to remove the restriction on the management interface before
proceeding with the FTP session, return to the storage router CLI session and
re-enable the restriction, using the following procedure.

1. show restrict — Verify that port 21 on the management interface is

currently open.

2. restrict mgmt ftp — Close the management interface to FTP

functions. No FTP functions will be allowed.

Understanding Diagnostics

The storage router performs hardware diagnostics when the unit is powered up.
Hardware diagnostics cannot be bypassed. If a hardware diagnostic fails, the
storage router halts. The boot process cannot be re-initiated.

If you experience a hardware diagnostic failure, contact HP technical support
personnel as described in the

“HP Technical Support”

section in the “About This

Guide” Chapter for further instructions.

The storage router performs additional “soft” diagnostics after the hardware
diagnostics complete on power up and after every system reboot. If necessary, the
soft diagnostics can be bypassed.

If you experience problems with soft diagnostics, contact HP technical support
personnel for assistance.

This manual is related to the following products: