HP StorageWorks IP Storage Router - Manual (Page 23)

Product Overview
23 IP Storage Router SR2122-2 User Guide
physical medium. See Chapter B, “Cable and Port Pinouts” for SFP module
specifications. Each Fibre Channel port has LEDs indicating its status, as
described in the “Front Panel LEDs” section that follows.
Front-Panel LEDs
The front-panel LEDs provide status indications about the storage router chassis
and its ports (see
Figure 4 ).
■ Each Gigabit Ethernet port, GE 1 and GE 2, has four LEDs, labeled LINK,
RX, TX, and FAULT. The LEDs are located to the left and right of each
Gigabit Ethernet port.
■ The FAULT, STATUS, and POWER LEDs indicate the overall status of the
storage router. The LEDs are located to the left of the CONSOLE port.
■ The 10/100 Ethernet management port, MGMT 10/100, has two LEDs,
labeled ACT and SPEED. The ACT LED is located at the left-bottom corner
of the port; the SPEED LED is located at the right-bottom corner of the port.
■ The 10/100 Ethernet HA port, HA 10/100, has two LEDs, labeled ACT and
SPEED. The ACT LED is located at the left-bottom corner of the port; the
SPEED LED is located at the right-bottom corner of the port.
■ Each Fibre Channel port has two LEDs, labeled LINK and FAULT. The LEDs
are located to the left and right of each Fibre Channel port.
Figure 4: Front panel LEDs
1
FC 1 LINK
2
FC 1 FAULT
3
FC 2 LINK
4
FC 2 FAULT
5
FAULT, STATUS, POWER
6
GE 1 LINK and RX
7
GE 1 TX and FAULT
8
GE 2 LINK AND RX
9
GE 2 TX and FAULT
1 2 4 5 6 7 8 9 3
hp StorageWorks IP storage router 2122-2
15004