Configuring an ip route, Verifying and saving configuration – HP StorageWorks IP Storage Router User Manual
Page 116
Configuring VLAN
116
IP Storage Router SR2122-2 User Guide
Configuring an IP Route
Configuring an IP route to access the VLAN consists of specifying a static route
that uses a gateway attached to the desired VLAN. To configure an IP route.
1. enable — Enter Administration mode.
2. ip route 10.2.90.285/32 10.2.10.233, interface ge2,
and VLAN 100
— Specify the IP address and subnet mask
10.2.90.285/32 of the destination. Set the subnet mask to
255.255.255.255. In this example the subnet mask was set using CIDR style
/32.
In addition, specify the gateway IP address
10.2.10.233, the interface name
ge2, and the VID 100.
Note:
To find the desired VID number, use the show vlan command. VIDs are listed
in the VLAN column.
.
Verifying and Saving Configuration
Verify VTP and VLAN operational and configuration information using the
procedures that follow. You can save the configuration at any time by using the
save all bootconfig
command. You must save the running configuration
to the bootable configuration for it to be retained in the storage router when it is
rebooted. Once you have saved the configuration, you can verify that the
configuration to be used when the storage router is rebooted matches the currently
running configuration.
To verify VTP operational information:
1. enable — Enter Administration mode.
2. show vtp — Display VTP operational information (
).
Example 2: Verifying VTP Operational Information
[Storage Router]# show vtp
Configuration Revision
: 8
Number of existing VLANs : 4
VTP Operating Mode
: Client
VTP Domain Name
: opus