Prerequisite tasks, Vlan encapsulation, Configuration tasks – HP StorageWorks IP Storage Router User Manual
Page 112
Configuring VLAN
112
IP Storage Router SR2122-2 User Guide
Prerequisite Tasks
Before configuring for VLAN, make sure you have configured all system
parameters as described in
Chapter 5, “Configuring the Storage Router”
Chapter 6, “Configuring System Parameters”
VLAN Encapsulation
The storage router uses the IEEE 802.1Q standard for VLAN encapsulation.
Note:
If the storage router is connected to a switch, the switch port must be configured
as a trunk port and the encapsulation set to 802.1Q, not Inter-Switch Link (ISL), which is
the default setting for trunk ports.
Configuration Tasks
To configure for VLAN on the storage router:
1. Configure for VLAN using the VLAN Trunking Protocol (VTP) or Configure
for VLAN without using VTP.
2. Configure an IP route.
3. Verify and save configuration.
Note:
You can verify and save the configuration at any point in the process of
performing the configuration tasks. Save your configuration by using the
save all bootconfig
CLI command. This command saves all configuration data
to the bootable configuration, which is then used when the storage router is rebooted.
4. Proceed to
Chapter 8, “Configuring SCSI Routing”
to configure SCSI routing
and to assign a VLAN to a SCSI routing instance.
contrasts configuring the storage router for VLAN with VTP and
without VTP.