HP StorageWorks IP Storage Router - Manual (Page 34)

Installation
34 IP Storage Router SR2122-2 User Guide
WARNING: Because invisible radiation may be emitted from the aperture of
the port when no fiber cable is connected, avoid exposure to radiation and do
not stare into open apertures. To see translated versions of the warning, refer
to the Regulatory Compliance and Safety document that accompanied the
device.
The Gigabit Ethernet ports use fiber-optic SFP modules with either MT-RJ
connectors (see
Figure 13 ) or LC connectors (see Figure 14 ). The Fibre Channel
ports use fiber-optic SFP modules with LC connectors (see Figure 14 ). Refer to
Table 3 to determine what types of SFP modules you can install in the Gigabit
Ethernet and Fibre Channel ports. See Appendix B, “Cable and Port Pinouts,” for
SFP module specifications.
Figure 13: MT-RJ fiber-optic connector and SFP module
Caution: Protect your fiber-optic SFP modules by inserting clean dust covers
into the SFPs after the cables are extracted from them. Be sure to clean the
optic surfaces of the fiber cables before you plug them back into the optical
bores of another SFP module. Avoid getting dust and other contaminants into
the optical bores of your SFP modules; the optics will not work correctly when
obstructed with dust.
MT-RJ plug
SFP module