HP StorageWorks IP Storage Router - Manual (Page 185)

Maintaining and Managing the Storage Router
185 IP Storage Router SR2122-2 User Guide
* Select "apps" to remove active applications and
retain system
configuration settings.
* Select "system" to remove active applications and
system
configuration settings.
* Select "saved" to remove all backup configurations
from disk.
* Select "all" to remove active applications, system
configuration, and saved configurations.
The system configuration includes the management port,
dns, admin and monitor login, ntp, and snmp. You will
need to use the console
to reconfigure the management port if you erase the
system configuration.
The system will reboot if you select "apps", "system",
or "all".
Erase what? [apps/system/saved/all/cancel (cancel)]
Note: After the move, use the EIA/TIA-232 console connection to configure the
management interface IP address and other required system information. (See the
“Initial System Configuration Script” section in Chapter 5, “Configuring the Storage
Router” for details.) Then configure the storage router via the Setup Configuration
Wizards or other CLI commands, or via the web-based GUI.
Reset and Retain System Settings
If an existing storage server is going to be used for testing purposes (system
configuration information will not be changed) and then restored to its current
configuration, use the following procedure:
1. enable — Enter Administrator mode.