HP Storage Mirroring Software - Manual (Page 649)

Evaluations Page 648 of 677
Initiating failback
When failover occurs, a source machine has failed. The steps below must be used to
complete failback, which releases the source identity from the target.
1. If this were a real failure scenario and not an evaluation, you would first verify that
your source machine is not connected to the network. If it is, you would have to
disconnect it from the network.
2. Next you would resolve the source machine problem that caused the failure.
Note: Do not connect the source machine to the network at this time.
3. In the Failover Control Center, select the target that is currently standing in for the
failed source.
4. Select the failed source and click Failback.
5. You will be prompted to determine if you want to continue monitoring the source.
Do not make any selections at this time.