HP Storage Mirroring Software - Manual (Page 129)

Storage Mirroring Console Page 128 of 677
Application Manager
To open the Application Manager, select Start, Programs, HP Storage Mirroring,
Recover, HP Storage Mirroring Application Manager.
Note: You can also start the Application Manager from the command line.
l
To start it in standard mode, run the command dtam /application, where
/application is /exchange, /sql, /fileprint, or /blackberry.
l
To start it in advanced mode, run the command dtam /application /advanced,
where /application is /exchange, /sql, /fileprint, or /blackberry.
The Application Manager allows you to establish application protection, monitor that
protection, and initiate application failover and failback.
When you select an application to protect in the Tasks list on the left pane, the Setup
tab on the right pane is a simple interface with four numbered steps. Steps 1 and 2 are
for the domain and servers. Step 3 is optional configuration and step 4 validates the
servers.
After protection has been established, use the Monitor tab to check on the status of your
protection.
l
Adding or managing servers
l
Changing Application Manager preferences