HP Storage Mirroring Software - Manual (Page 253)

Workload protection Page 252 of 677
Application workload ports
By default, Storage Mirroring Recover uses port 6320 for all TCP and UDP
communications. To verify or modify the ports, use the following instructions.
1. In the Application Manager, select Tools, Options.
2. Verify or modify the Service Listen Port as needed. All servers and clients in your
application workload protection must be using the same port.
Storage Mirroring Recover uses ICMP pings to monitor the source for failover. A failover
monitor will not be created if ICMP is blocked (although the data and application will still
be protected). You should configure your hardware to allow ICMP pings between the
source and target. If you cannot, you will have to monitor for a failure using the Storage
Mirroring Recover replication service. Use the Method to Monitor for Failover option
on the configuration Monitoring tab to
set your failover monitoring method .