HP Storage Mirroring Software - Manual (Page 408)

Workload monitoring Page 407 of 677
73 Connected to ip://xxx.xxx.xxx.xxx
A source machine has successfully connected a replication set to a target
machine.
74 Connection paused with ip://xxx.xxx.xxx.xxx
A network connection between the source and the target exists and is
available for data transmission, but data is being held in queue and is not
being transmitted to the target. This happens because the target machine
cannot write data to disk fast enough. Storage Mirroring Recover will
resolve this issue on its own by transmitting the data in queue when the
target catches up.
75 Connection resumed with ip://xxx.xxx.xxx.xxx
The transmission of data from the source machine to the target machine
has resumed.
76 Connection failed to ip://xxx.xxx.xxx.xxx
An attempt to establish a network connection between a source machine
and target machine has failed. Check your network connections and verify
that the target machine is still online.
77 Connection lost with IP address address
The network connection previously established between a source
machine and target machine has been lost. Check your network
connections and troubleshoot to see why the connection was lost.
78 Auto-disconnect threshold has been reached.
The Storage Mirroring Recover queue has exceeded its limit, and the
auto-disconnect process will disconnect the source and target connection.
The auto-reconnect process will automatically reestablish the connection
if the auto-reconnect feature is enabled. If the auto-reconnect feature is not
enabled, you must first verify that the connection between the source and
target has been broken, and then manually reestablish the connection in
the Replication Console.
79 Memory freed to bring Double-Take memory usage below the limit
Data in the source queue has been sent to the target machine, bringing
the pagefile below its limit.
80 Trying to auto-retransmit to ip://xxx.xxx.xxx.xxx
Storage Mirroring Recover is attempting to automatically reconnect
previously established source and target connections after a server reboot
or auto-disconnect. This is also referred to as the auto-reconnect process.