HP Storage Mirroring Software - Manual (Page 410)

Workload monitoring Page 409 of 677
94 Verification started con_id
The verification process of confirming that the Storage Mirroring Recover
data on the target is identical to the data on the source has started.
95 Verification ended con_id
The verification process of confirming that the Storage Mirroring Recover
data on the target is identical to the data on the source has ended.
97 Restore started con_id
The restoration process of copying the up-to-date data from the target back
to the original source machine has started.
98 Restore completed con_id
The restoration process of copying the up-to-date data from the target back
to the original source machine has been completed.
99 RepSet Modified: repset_ name
This message means that the specified replication set has been modified.
100 Failover condition has been met and user intervention is required
Storage Mirroring Recover has determined that the source has failed, and
requires manual intervention to start the failover process.
101 Failover in progress!!!
The conditions for failover to occur have been met, and the failover
process has started.
102 Target full!
The disk to which data is being written on the target is full. This issue may
be resolved by deleting files on the target machine or by adding another
disk.
801 Auto-disconnect has occurred on IP address with connection con_id
Disconnected replication set name: repset_name.
Auto-disconnect has occurred for the specified connection. This is due to
the source queue filling up because of a network or target failure or
bottleneck.
10001 Activation key is not valid.
An invalid activation code was identified when the Storage Mirroring
service was started.
10002 Evaluation period has expired.
The evaluation license has expired.