HP Storage Mirroring Software - Manual (Page 272)

Workload protection Page 271 of 677
Protecting a Hyper-V server to a Hyper-V server
Use these instructions to protect a virtual machine on a Hyper-V server or cluster, where
you want to protect the host-level virtual disk files (the .vhd files), to a virtual server on a
Hyper-V server.
1. Open the Storage Mirroring Console by selecting Start, Programs, Storage
Mirroring, Storage Mirroring Console.
2. Click Get Started from the toolbar.
3. Select Storage Mirroring Recover and click Next.
4. Select Protect a Hyper-V virtual machine using host-level protection and click
Next.
5. Specify your source server. This is the Hyper-V source that contains the virtual
machine that you want to protect.
l
Server/Cluster—Specify the name or IP address of the Hyper-V server or
cluster that is hosting the virtual machine that you want to protect. You can
click Browse to select a server from a network drill-down list.
Note: If you enter the source server's fully-qualified domain name, the
Storage Mirroring Console will resolve the entry to the server short
name. If that short name resides in two different domains, this could
result in name resolution issues. In this case, enter the IP address of
the server.