HP Storage Mirroring Software - Manual (Page 153)

Workload protection Page 152 of 677
l
Source Server—Specify the source server that contains the replication set
that is going to be simulated to the TDU.
l
Replication Set—At least one replication set must exist on the source before
establishing a connection. Specify the replication set that will be connected
to the TDU.
l
Target Server—Select the Diagnostics target.
l
Route—After selecting the Diagnostics target, the Route will automatically
be populated with Throughput Diagnostics Utility (TDU).
l
Mappings—Mappings are not required when simulating a connection
because no data is actually transmitted to the target.
l
Start Mirror on Connection—Make sure this option is selected so that your
simulation will be realistic.
l
Start Replication on Connection—Make sure this option is selected so that
your simulation will be realistic.
l
Block Target Path(s) on Connection—This option is not needed when
simulating a connection because no data is actually transmitted to the target.
5. Click Connect to establish the connection. The simulation data will be logged to
the Storage Mirroring Recover statistics file.
6. Repeat step 1 to run the diagnostics utility after the simulation is complete.