HP Storage Mirroring Software - Manual (Page 260)

Workload protection Page 259 of 677
Protecting a physical or virtual server to a Hyper-V or ESX
server
Use these instructions to protect a physical or virtual server, where you want to protect
the volumes from the physical server or the volumes from within the virtual guest
operating system, to a virtual server on a Hyper-V or ESX server.
1. Open the Storage Mirroring Console by selecting Start, Programs, Storage
Mirroring, Storage Mirroring Console.
2. Click Get Started from the toolbar.
3. Select Storage Mirroring Recover and click Next.
4. Select Protect an entire server using a Hyper-V or ESX virtual machine and
click Next.
5. Specify the source server that you want to protect. This is the physical or virtual
server that you want to protect.
l
Server—Specify the name or IP address of the physical or virtual server that
you want to protect. You can click Browse to select a server from a network
drill-down list.
Note: If you enter the source server's fully-qualified domain name, the
Storage Mirroring Console will resolve the entry to the server short
name. If that short name resides in two different domains, this could
result in name resolution issues. In this case, enter the IP address of
the server.