HP Storage Mirroring Software - Manual (Page 385)

Workload monitoring Page 384 of 677
Target data state
l
OK—The data on the target is in a good state.
l
Mirroring—The target is in the middle of a mirror process. The data
will not be in a good state until the mirror is complete.
l
Mirror Required—The data on the target is not in a good state
because a remirror is required. This may be caused by an incomplete
or stopped mirror or an operation may have been dropped on the target.
l
Restore required—The data on the source and target do not match
because of a failover condition. Restore the data from the target back to
the source. If you want to discard the changes on the target, you can
remirror to resynchronize the source and target.
l
Snapshot reverted—The data on the source and target do not match
because a snapshot has been applied on the target. Restore the data
from the target back to the source. If you want to discard the changes on
the target, you can remirror to resynchronize the source and target.
Target route
The IP address on the target used for Storage Mirroring Recover
transmissions.
Compression
l
On / Level—Data is compressed at the level specified
l
Off—Data is not compressed
Bandwidth limit
If bandwidth limiting has been set, this statistic identifies the limit. The
keyword Unlimited means there is no bandwidth limit set for the
connection.
Connected since
The date and time indicating when the current connection was made. This
field is blank, indicating that a TCP/IP socket is not present, when the
connection is waiting on transmit options or if the transmission has been
stopped. This field will maintain the date and time, indicating that a
TCP/IP socket is present, when transmission has been paused.
Mirror status
l
Calculating—The amount of data to be mirrored is being calculated.