GW Instek GDM-8261A User manual - Manual (Page 72)

GDM-8261A User Manual
72
2. Set Count Press the Enter key to set the
number of measurements (counts)
that will be used for the Stats
function. The Count menu appears.
AUTO
ENTER
1st display Shows the count number as continuous
2nd display Indicates the count setting
2a.Continuous
count 1. To set the count to Continuous
and to start measurement, press
Enter when CONTINU is
displayed on the 1st display.
2. Measurement starts
automatically.
AUTO
ENTER
2b. User-defined
count 1. To set a user-defined count
number, press the Left key
followed by Up when
CONTINU is displayed on the
screen. The Count setting menu
will appear.
HOLD
1st display Shows the count number (2~100,000)
2nd display Indicates the count setting
2. Use the Left/Right key to move
the flashing point (cursor), and
use the Up/Down key to change
the count number.
HOLD TRIG