Calculate commands – GW Instek GDM-8261A User manual User Manual
Page 194

GDM-8261A User Manual
194
[SENSe:]FRESistance:NPLCycles
Sets the integration time for 4W resistance measurements in PLCs (power
line cycles). Where one PLC is equal to 16.6 milliseconds. For any
parameter, the DMM will automatically set the PLC to the closest
acceptable PLC value (0.025, 0.1, 0.25, 1, 2, 12).
Parameter: NPLCycles(
Example: SENS:FRES:NPLC MAX
Sets the integration time to the maximum for 4W resistance measurements.
[SENSe:]FRESistance:NPLCycles?
Returns the integration time for 4W resistance measurements in PLCs
(power line cycles). Where one PLC is equal to 16.6 milliseconds.
Return parameter: 0.025, 0.1, 0.25, 1, 2, 12
CALCulate Commands
CALCulate:FUNCtion
Sets the Advanced function.
Parameter: OFF | MIN | MAX | HOLD | REL | COMP | DB | DBM | STORE |
AVER | MXB | INV | REF
Example: CALC:FUNC REL
Sets the Advanced function to REL (relative)
CALCulate:FUNCtion?
Returns the current Advanced function.
CALCulate:STATe
Turns the Advanced function on/off.
Parameter: ON|OFF
Example: CALC:STAT OFF
Turns the Advanced function off.
CALCulate:STATe?
Returns the status of the Advanced function.
Return Parameter: 0 | 1, 1=ON, 0=OFF
CALCulate:MINimun?
Returns the minimum value from the Max/Min measurement.
CALCulate:MAXimun?
Returns the maximum value from the Max/Min measurement.
CALCulate:HOLD:REFerence
Sets the percentage threshold for the Hold function.
Parameter:
Example: CALC:HOLD:REF 10
Sets the hold percentage to 10%.