GW Instek GDM-8261A User manual - Manual (Page 108)

GDM-8261A User Manual
108
2. Route the wires as shown below via the two openings
(left and right) at the front cover.
Note
When using thermocouple wiring, please use
extension wires so that the cold junction points are
external to the scanner card. Connecting
thermocouple wiring directly to the scanner box is
not recommended due to the radiant heat from the
internal components.
Best if longer
than 20cm
Thermocouple
wire
Cold junction
points
Extension
wires
Hot junction
point
3. Bundle the wires at the front cover using the holes at
the bottom.